You have reached the legacy GHI Electronics, LLC website, for the new website please visit here. For the new forum please visit here.

This legacy website will be taken offline at the end of this year. If there is anything that you would like to archive and save for future reference please do so.

Reflow Profile and Assembly Instructions

Last modified November 9, 2015

Baking

GHI SoMs are moisture sensitive. It is recommended that the device be baked before reflow. The recommended baking time and temperature is 24 hours at 124 degrees Celsius.

Recommended Reflow Profile

NOTE: The profiles shown are based on SAC 305 solder (3% silver, 0.5% copper).  The thermal mass of the assembled board and the sensitivity of the comonents on it affect the total dwell time. Differences in the two profiles are where they reach their respective peak temperatures, as well as the time abover liquidus (TAL). The shorter profile of the two would apply to smaller assemblies, where as the longer profile would apply to lareger assemblies, such as backplanes or high-density boards. The process window is described by the shaded area. These profiles are starting-points (mainly guidance), the particulars of your oven and your assembly will determine your final process. 

  

  

Leave feedback about this document.
Let us know if the information presented here was accurate, helpful and if you have any suggestions.
Leave feedback about this document.
Let us know if the information presented here was accurate, helpful and if you have any suggestions.

* Indicates required fields.
This form is only for feedback not support.
Review our how to find information guide on locating helpful resources.