You must be logged in to reply.

Page 2 of 2 out of 14 messages.

Tech Talk with Gus 15 - Raspberry Pi & FEZ Duino Pi

3 likes
Reply #10 — Posted 2yr ago
by Gus_ghielectroncs | Employee
Reply #10 — Posted 2yr ago
by Gus_ghielectroncs | Employee
@Bill_Wyo - this is where the community can work together on whatever changes they like and group order the boards to lower the cost.

You may even use this as an educational project.

Tech talk is not just about things we sell. It is a general talk about technology. I am aiming for educational and entertaining.
2 likes
Reply #11 — Posted 2yr ago
by Bill_Wyo | Senior | 2,584 exp
Reply #11 — Posted 2yr ago
by Bill_Wyo | Senior | 2,584 exp
@Gus - Thank you Gus. Your attitude makes me feel good about doing business with GHI.
Reply #12 — Posted 2yr ago
by devhammer | Legend | 55,820 exp
Reply #12 — Posted 2yr ago
by devhammer | Legend | 55,820 exp
Bill_Wyo says:

I started using Gadgeteer because I was not good at hardware. I did not expect to end up soldering 0603 resistors to pcbs. I am not complaining, I love a challenge but I am puzzled.

Hot air rework station and solder paste. Makes a lot of things easier. But for goodness sake, skip the lead-free solder paste. That stuff is a pain to work with.

Should be able to get stencils from OSHPark to go with your boards for a reasonable price, or you can just add paste by hand if you're patient.
Reply #13 — Posted 2yr ago
by Brett | Superhuman | 125,590 exp
Reply #13 — Posted 2yr ago
by Brett | Superhuman | 125,590 exp
OSHstencils for cheap kapton based stencils are easy too.

Page 2 of 2 out of 14 messages.

You must be logged in to reply.